Hi again,
I wasn't expecting I'd be replying to myself; but here goes:
I took my Kisado with me to compare it with the connectors at the supply
house. The pin density is identical. Is anyone interested in a whole
box of these card connectors? There are two kinds, one which has a
frame for holding a HuCard, and another with no frame at all, just bare
pins. If someone expresses some interest, I will purchase and
photograph a couple samples tomorrow.
I'm surprised nobody replied to my earlier post, as I was under the
impression that the connectors were the most difficult to find component
for making convertors. Am I wrong?
Anyway, as with the last email, feel free to reply on or off-list.
-Andy
A. Cassady wrote:
> Hi. I was wondering what the pin spacing should be on the HuCard
> connector. I found a pile of NOS card connectors, which say 0.05" for
> the distance between pins. Is this correct for PCE HuCards? I don't
> have anything to measure a card with at the moment and I wouldn't want
> to buy a pile of the wrong connector. Physically, the connector looks
> the same as the one inside the PC Engine PAC for the Laseractive.
> Please write(on or off list is fine) as soon as you can. Thank you!
>
> -Andy
>
>
--- Turbo List Information ---------------------------------------------
The Turbo List: Our drivers carry less than $20 in cash (mainly because
they're always broke from buying TG/Duo/PCE games), but none the less,
it's just something that you should be aware of.
------------------------------------------------------------------------